12
Installing the Handsfree Kit
1
Connect the
GREEN
Ignition Sense wire to an
ignition-switched location on the fuse block. When the
ignition is off, the ignition sense line is low.
2
Connect the
YELLOW
Entertainment Mute Wire to the
vehicle’s entertainment system.
Note:
This feature is only operational if the vehicle’s
radio supports this capability. Installation may require
an optional relay (not included). The mute line is an
active low signal.
3
Connect the
RED
positive battery lead to a point in the
vehicle’s fuse box that is fused at 5 amp.
4
Connect the
BLACK
ground wire to the vehicle chassis.
5
Inspect all connections.
Note:
The
ORANGE
and
BLUE
wires are not used.
(These wires are used to connect the line-level audio to
the vehicle radio, if the radio supports this feature.)
Note:
The system's handsfree audio has been optimized
for the external speaker. Routing the audio output through
the vehicle's entertainment system may alter the
handsfree audio performance.
BTHandsfree_multi.book Page 12 Tuesday, July 12, 2005 8:46 AM
To Next Page
Loading...
