13
English
English
TEST MODE
Once the installation of the CDM is complete, the
display can be tested to ensure proper installation
and functionality. To initiate the test mode:
1. Plug the charger into an AC power outlet.
2. Insert the end of a large paper clip into the
pinhole below the display on the front of the
charger. The paper clip should be inserted
perpendicular to the desktop. A “click” indicates
the toggle button has been accessed.
3. Press and hold the toggle button for five
seconds to access the test sequence.
4. The display will cycle through a series of
displays (shown below) to indicate proper
installation and operation.
Start
Line 1
Line 2
Line 1
Line 2
Line 1
Line 2
Line 1 TEST MODE aa.bb
Line 2 TEST MODE aa.bb
Line 1
TEST MODE aa.bb
Line 2
TEST MODE aa.bb
Every
10.0 sec
CDM_Install - B.fm Page 13 Monday, February 10, 2003 2:51 PM
To Next Page
Loading...
