3 - 8 LI4278 Product Reference Guide
Linear imager scanner is
disabled.
For Synapse or IBM-468x mode,
enable the linear imager scanner via
the host interface.
The red illumination does not appear
when the trigger is pulled.
No power to the linear imager
scanner.
Check battery and charging contacts;
ensure that end cap to battery chamber
is secured; ensure all power and cable
connections to cradle are secure.
Interface/power cables are loose. Check battery and charging contacts;
ensure power and cable connections to
cradle are secure.
Table 3-1
Troubleshooting (Continued)
Problem Possible Causes Possible Solutions
NOTE If after performing these checks the symbol still does not scan, contact the distributor or contact Motorola
Solutions Support. See page xxiii for contact information.
To Next Page
Loading...
