Quick Reference Guide 7
Programming Bar Codes
Following are some frequently used programming bar codes.
NOTE For additional host types, refer to the LS4208 Product
Reference Guide, p/n 72E-69413-xx, available on the LS4208 CD, or
on the Symbol website: http://www.symbol.com/manuals.
Set Defaults
Scan SET DEFAULTS to set all parameters to their default values.
SET DEFAULTS
Scanning Modes
Scan the appropriate bar code below to determine the scanning pattern.
• SINGLE LINE ONLY - No up and down scan line movement (no raster).
• MULTI-LINE SMART RASTER - The scan line begins as a single line and moves up
and down (rasters) when a partial scan of a bar code is detected, or no bar code is
decoded 500 ms after the trigger is pulled.
• MULTI-LINE ALWAYS RASTER (default) - Rastering (up and down scan line
movement) begins immediately.
SINGLE LINE ONLY
MULTI-LINE SMART RASTER
MULTI-LINE ALWAYS RASTER (Default)
To Next Page
Loading...
Need help?
General
