Scan
27
Scan
Introduction
The scan feature allows you to monitor activity on dif-
ferent conventional and trunked modes by scanning a
"scan list" of members (up to 8 members).
Turning Scan On/Off
Press the (scan) button when in any system/
talkgroup or conventional position. The scanning fea-
ture will be enabled. If you desire to turn off the scan-
ning feature, again press (scan) button.
For as long as "SCAN ON" is selected, the ( ) scan
icon will be displayed and the radio will scan for activity
in the channels/talkgroups that are defined in the scan
lists of the present mode.
NOTE
To initiate a call properly during scan mode, press
the PTT switch for a few seconds.
Programming/Viewing a Scan List
MAX638 allows front panel programming to allow the
operator to edit the scan list.
Press (menu) button until the display shows:
Press the (select) button to select "Scan Program-
ming/ Viewing mode".
Scan
Scan
Menu
Sel
This Manual: http://www.manuallib.com/file/2545286
To Next Page
Loading...
