Transceiver Performance Testing Setup 3-3
Setup:
Set up the DMR Transmitter and Receiver Test as per Figure 3-1.
a. Connect the Programming cable to the radio and to the computer.
b. Remove RF plug (orange) as shown in Figure 4.5, on page 4-3
c. Connect the RF antenna adaptor to the 50 Ohm RF Input/Output port of the radio.
Connect the other end of the RF antenna adaptor to the T/R port of the Radio Test Set 3920 using
the RF cable shown in Figure 3-1.
See “RF Adaptor Assembly” on page 4-3 for complete RF Adaptor Assembly steps.
Figure 3-1. DMR Radio Transmitter and Receiver Testing Setup
T/R Port
Power Supply
Ant. Input / Output
Programming Cable
Modulated RF Test
Signal / Tx
modulated RF Signal
Battery Eliminator
To Next Page
Loading...