5-12 Disassembly/Reassembly Procedures: Radio Disassembly – Detailed
5.6.3 Keypad, Display, and Keypad Board Disassembly
1. If the disassembly of the keypad, the keypad printed circuit board, or the display is required,
remove the retainer by using a TORX screwdriver with a T6 head to remove the four screws.
2. Slide out the retainer from the housing assembly.
3. Disconnect the speaker flex, LCD flex and PTT flex from the keypad board.
Figure 5-8. Keypad, Display, and Keypad Board disassembly for Full Keypad
NOTE
The LCD, keypad board and keypad can be removed without the use of tools.
To Next Page
Loading...