Disassembly/Reassembly Procedures: Radio Reassembly - Detailed 5-23
5.7.3 Chassis Reassembly
O-ring reassembly:
i. Ensure that the main O-ring is not twisted and untangle it to its actual form if needed
before performing reassembly.
ii. Insert D into the bottom two notches on the chassis.
iii. Fit C around the bottom two corners of the chassis.
iv. Insert B1 to B4 following the sequence as shown in Figure 5-20.
v. Secure A into the top 2 notches of the chassis.
vi. Replace the battery contact seal.
Figure 5-20. O-ring reassembly.
A
B1
B2
B3
B4
C
D
Battery Contact Seal
To Next Page
Loading...