Motorola MOTOTRBO XiR P8668 - 5.6.4 Speaker, Microphone, and Universal Connector Flex Disassembly

5-14 Disassembly/Reassembly Procedures: Radio Disassembly – Detailed
5.6.4 Speaker, Microphone, and Universal Connector Flex Disassembly
1. Pull the microphone boot from its seated position.
2. Remove the speaker retainer screw using the TORX T6 screwdriver.
3. Peel-off the universal connector flex circuit escutcheon.
4. Pull the UC flex circuit (adhesive held) backer board from the font cover. Push the universal
connector flex through the UC slot into the housing.
5. Remove the speaker retainer from the speaker assembly.
6. Remove the assembly from the front housing.
Figure 5-10. Speaker removal for Full Keypad
Speaker Retainer
Speaker, Mic and Flex Assembly
UC Slot
Mic Boot
Screw