5-22 Disassembly/Reassembly Procedures: Radio Reassembly - Detailed
5.7.2 Keypad, Display and Keypad Board Reassembly
1. Place the LCD and keypad followed by the keypad board and keypad retainer in the housing.
2. Reconnect the speaker flex, LCD flex and PTT flex to the keypad board and keypad retainer.
3. Slide the keypad retainer in to the latch.
4. Use a TORX screwdriver with a T6 head to affix the screws.
Figure 5-19. Keypad, Display, and Keypad Board reassembly for Full Keypad
To Next Page
Loading...