Disassembly/Reassembly Procedures: Radio Reassembly - Detailed 5-21
Figure 5-18. Speaker reassembly for Non Keypad
2. Insert the flexes through the speaker retainer so that the speaker retainer is placed directly on
the speaker assembly.
3. Slide the universal connector flex into UC slot.
4. Hook in the speaker retainer with speaker assembly at the top left corner of the housing.
5. Affix the appropriate screw on the speaker retainer.
6. Place the mic boot in the appropriate slot.
7. Place a new universal connector escutcheon on the universal connector flex circuit.
NOTE
Ensure all the flexes are above the speaker retainer.
Speaker Retainer
Speaker, Mic and Flex
UC Slot
To Next Page
Loading...