5-16 Disassembly/Reassembly Procedures: Radio Disassembly – Detailed
Figure 5-12. Speaker removal for Non-Keypad
1. Pull the rubber microphone boot from its seated position.
2. Remove the screw using the TORX T6 screwdriver.
3. Disconnect the PTT flex and peel the speaker assembly flex from the housing.
4. Peel off the universal connector flex circuit escutcheon.
5. Pull the UC flex circuit (adhesive held) backer board from the font cover. Push the universal
connector flex through the UC slot into the housing.
6. Remove the speaker retainer from the speaker assembly.
7. Remove the assembly from the front housing.
Speaker Retainer
Speaker, Mic and Flex Assembly
UC Slot
PTT flex connector
Screw
To Next Page
Loading...