Installation 3
Installation
This section describes the tools and equipment, planning requirements, and product
inspections necessary for a smooth installation of the MW810. Proper planning will help to
ensure that the installation is completed without difficulty and that no damage occurs to the
units or the vehicle.
Unpacking
Unpack your shipment and check the contents to ensure that you have received all the
specified items.
Thoroughly inspect the equipment for shipping damage as soon as possible after delivery.
Report
any damage you find to your Motorola Customer Service representative immediately.
Save the packing carton and anti-static plastic bags for storage and shipping. Both the
sh
ipping carton and the anti-static bags protect the MW810 Mobile Workstation components
from physical and electrostatic damage.
The following optional parts can be used to mount the MW810:
• Display Mount assembly - See “12.1“ Display” on page 11. and “8.4” Display” on page 14
• CPU Box mount/trunnion for the MW810 Mobile Workstation CPU -
See “CPU Box Mount/Trunnion” on page 25.
• Gamber Johnson Mounts -
See:
http://concept.gamberjohnson.com/catalog/category/docking/motorola/15
Preparing to Install the MW810 Mobile Workstation Inside the Vehicle
Tools
The following tools and service aids are required for installation:
• 3/8” nut driver
• 1/2”, 3/8” or 7/16” wrench
• No. 2 and 4 Phillips screwdriver
• Drill with 3/16” drill bit
The MW810 Mobile Workstation is a reliable product when installed
correctly. However, performance can be seriously impaired if it is not
installed correctly. Thoughtful planning can make the difference.
Please note that installing any part of the MW810 Mobile Workstation
must be according to the instructions provided in this manual.
To Next Page
Loading...
