Installation 45
Turning On the MW810
Before powering ON the MW810:
• Verify proper display to CPU cable connection on both sides.
• Verify keyboard connection to the display.
• Verify that the vehicle power system can supply at least 15 Amps.
• Check that the power cables are plugged into the power connectors of the CPU Box and
th
e
display.
• Switch ON the main power switch (MAIN SWITCH) on the back panel of the CPU Box.
If the MW810 Mobile Workstation is connected through the ignition switch, insert the car
key i
nto the ignition switch and rotate it to ACC position, or start the engine, before
powering ON.
To power the workstation, press the Power button on the front panel of the CPU Box, or press
th
e Workstation Power button on the display.
Turn-on Modes
The MW810 Mobile Workstation has four optional turn-on modes using the ignition key and
the Power buttons of the display or CPU Box. Setting an optional turn-on mode is performed
by software application.
Using the Power Button or Ignition Key to Start the MW810
This mode is the default workstation setting.
The MW810 Mobile Workstation can be turned ON by either one of the following methods:
1. Press the Power button of the CPU Box or Display, regardless of the ignition key
posi
tion.
2. Turn ON the ignition switch.
The MW810 Mobile Workstation can be turned OFF by either one of the following methods:
1. When the ignition switch is in OFF position, press the Power button of the CPU Box or
Di
spl
ay. Note that when the ignition switch is in ON position, the Power buttons are
ignored.
2. Turn OFF the MW810 Mobile Workstation via the Operating System (OS).
Using the Power Button and Ignition Key to Start the MW810 Mobile Workstation
The MW810 Mobile Workstation can be turned ON by the following method:
1. Turn ON the ignition switch.
2. Press the Power button of the CPU Box or Display to turn ON the MW810.
The main power switch on the CPU Box back panel (MAIN SWITCH) must
be in OFF position before connecting to power supply source.
To Next Page
Loading...
