50 MW810 Vehicle Mobile Workstation Installation Manual
U-Blox U-Center Configuration
The u-center GPS Evaluation Software provides a powerful tool for evaluation, performance
analysis and configuration of u-blox GPS receivers. u-blox GPS receivers can be configured
using the u-center Evaluation Software.
To configure the u-blox GPS receiver, perform the following steps:
Step 1. Download the U-Center application from: http://www.u-blox.com/products/
u_center.
html.
Step 2. Install the U-Center application on the MW810.
Step 3. Click START > Pr
ograms > U-Blox Products > Tools > U-Center Application to run
the U-Center application.
Step 4. From the application toolbar, click the “Configuration View Window” button .
The left window pane enables to navigate to the configuration setting screens.
Step 5. From the left window pane, select UBX >
CFG (Config) >EKF (EKF Settings).
Step 6. Check the “EKF Enabled”, Clear Calibration Data, Clear Temperature Table options
and click the button to save.
To Next Page
Loading...
