EasyManua.ls Logo

Motorola PMPN4283 - Charger Setup

Motorola PMPN4283
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
31
English
Charger Setup
The charger Keypad is located beside the Display associated with
Pocket 1.
Figure 5: Charger Display and Keypad
Table 19: Preparing Other Motorola Solutions Nickel Batteries or
Unknown Batteries for Shipment
Status Charger Display LED Indicator
Charger Powers On
IMPRES 2
CHARGER
Green for approximately one
second
Battery Detected
Other Motorola Solutions
battery
Unknown battery
WRONG BATT TYPE
CANNOT SHIP LI
Flashing Red
Fault (Battery Faulted)
Warning:
NOT CHARGEABLE
REMOVE& REINSERT
Flashing Red
Standby
Battery is waiting to rapid
charge.
Battery may be too hot,
too cold, or low voltage.
Warning:
HOT BATTERY
WAITING TO CHRGE
or
COLD BATTERY
WAITING TO CHRGE
or
VERY LOW BATTERY
WAITING TO CHRGE
Flashing Amber
Empty all charger pockets before entering charger setup.
MN003555A01.book Page 31 Wednesday, February 14, 2018 2:40 PM

Related product manuals