Motorola PR400 Commercial Series - Radio Calls; Selective Radio Inhibit; Receive a Selective Call (Conventional Operation Only); Send a Selective Call (Conventional Operation Only)

35
English
RADIO CALLS
RADIO CALLS
SELECTIVE RADIO INHIBIT
Your radio is equipped with a security feature
that can temporarily render the unit inoperative
when an inhibit signal is sent from the base
station.
This feature is commonly used to disable
radios:
• In case of theft
• For system control reasons
When your radio has been rendered
inoperative by the base station,all controls will
be inoperative except for the On/Off button
and the display shows INHIBIT.
RECEIVE A SELECTIVE CALL F
(CONVENTIONAL OPERATION ONLY)
When you receive a selective call:
• The display shows F and the prepro-
grammed name or ID (MDC1200) of the
calling radio, or you will hear a Call Alert
tone (QCII) of the calling radio.
• The LED indicator flashes yellow, if pro-
grammed by your dealer/programmer.
• You hear two high-pitched tones.
SEND A SELECTIVE CALL
(CONVENTIONAL OPERATION ONLY)
You can send a Selective Call to a particular
radio or to a group of radios, as programmed
by your dealer.
Press the preprogrammed Radio Call button
(see page 23), and proceed to step 4.
–
or –
1 To acknowledge the call, press and release the
PTT button.
2 Press and hold the PTT button to talk; release
to listen.
03_RadioCall.fm Page 35 Thursday, July 21, 2005 3:21 PM