41
English
SCAN
DELETE A NUISANCE CHANNEL/
TALKGROUP
Note: Your dealer/programmer must
preprogram a button to access this
feature (see page 23).
If a channel/talkgroup continually generates
unwanted calls or noise (a “nuisance” channel/
talkgroup), you can temporarily remove it from
the scan list:
Restore Channels/Talkgroups to the Scan
List
1 While the radio is on the nuisance channel/
talkgroup, press the preprogrammed
Nuisance Channel Delete button until you
hear a tone.
2 Release the Nuisance Channel Delete
button. The nuisance channel/talkgroup is
deleted.
Note: You cannot temporarily delete the
channel/talkgroup that has been
preprogrammed by your dealer/
programmer as your designated
scan channel/talkgroup, a priority
channel/talkgroup, or the last
remaining channel/talkgroup in the
scan list.
1 Power off the radio. Once the radio is powered
on again, the deleted nuisance channels/
talkgroups are restored to the scan list.
– or –
1 Press the preprogrammed Scan button to stop
the scan.
2 Press the preprogrammed Scan button again
to start scanning again. The deleted nuisance
channels/talkgroups are restored to the scan
list.
–
or –
1 Select a channel/talkgroup that has not been
preprogrammed for scan by your dealer /
programmer to stop Scan. Once you return to
the original channel/talkgroup, the deleted
nuisance channels/talkgroups are restored to
the scan list.
04_Scan.fm Page 41 Monday, August 16, 2004 3:35 PM
To Next Page
Loading...
