39
English
SCAN
SCAN
Your radio is equipped with the Scan feature,
which allows you to monitor multiple channels/
talkgroups for voice activity. The radio will stop
on a channel/talkgroup when it detects activity
on it.
Scan lists are assigned per channel/talkgroup,
by your dealer/programmer. Your radio
automatically switches to a channel/talkgroup,
within that scan list, when it detects activity.
You can edit these lists through your radio’s
menu (see page 42).
• The LED indicator blinks green during scan
mode; it stops blinking when the radio
switches to an active channel/talkgroup.
•The Gsymbol appears on the display
while in scan mode.
There are two ways that your radio scans:
• System Scan (manual)
• Auto Scan (automatic)
TALKBACK
The Talkback feature allows you to respond to
a transmission while scanning. If transmission
is detected on a channel/talkgroup while
scanning, the radio will stop on that channel/
talkgroup for a default period of time after
activity has ceased. This is referred to as
“hangtime”. During this hangtime you may
respond by pressing the PTT button.
Note: The LED scan indicator stops blinking
while the radio is in hangtime. If the
PTT button is not pressed after the
preprogrammed hangtime, the radio
returns to scanning channels/
talkgroups.
START SYSTEM SCAN G
Press the preprogrammed Scan button to start
scanning channels/talkgroups in your scan list
(if Auto Scan is not enabled) (see page 23).
– or –
1 Select a channel/talkgroup that contains a
Scan list.
2
J to enter menu mode.
04_Scan.fm Page 39 Monday, August 16, 2004 3:35 PM
To Next Page
Loading...
