11
English
SCAN
SCAN
Your radio can monitor multiple channels in a
scan list. Your dealer can program up to four
different channels into each scan list. When
your radio detects activity on a scan list
channel, it will automatically switch to that
channel.
Note:
The same channels can be assigned to
different scan lists.
STARTING OR STOPPING SCAN
The green LED indicator blinks during a scan
operation and stops blinking when the radio
switches to a channel.
You can start or stop a scan operation by:
pressing the preprogrammed
Scan
button (see
page 4).
TALKBACK
The Talkback feature allows you to respond to a
transmission while scanning. If transmission is
detected on a channel while scanning, the radio
will stop on that channel for a preprogrammed
period of time. During this “hangtime” you may
respond by pressing the
PTT
.
Note:
If transmission ceases or if the
PTT
is
not pressed for a preprogrammed
duration, the radio continues to scan.
The LED scan indicator stops blinking
while the radio is in hangtime.
DELETING A NUISANCE CHANNEL
If a channel continually generates unwanted
calls or noise (a “nuisance” channel), use the
Scan
button to temporarily delete the channel
from the scan list.
Note:
You cannot delete a priority channel or
the last remaining channel in a scan list.
1
While the radio is on the nuisance channel, hold
down the
Scan
button until you hear a tone.
2
Release the
Scan
button. The nuisance
channel is deleted.
English.book Page 11 Friday, July 23, 1999 1:58 PM
To Next Page
Loading...
