Sending a Call
1. Turn radio on and select appropriate channel.
2. Press PTT, hold the microphone 1 to 2 inches (2.5 to 5 cm) from your mouth,
and speak clearly into it.
3. Release PTT to listen.
Receiving a Call
1. Turn radio on and adjust volume to the desired level.
2. Select desired channel.
3. To respond to an incoming call, press PTT, hold the microphone 1 to 2 inches
(2.5 to 5 cm) from your mouth, and speak clearly into it.
Deleting a Nuisance Channel During Scanning
1. While radio is on a nuisance channel, hold down preprogrammed Scan button
until you hear a tone.
2. Release Scan button.
Making a Phone Call
1. Press Phone button.
2. If access code is not heard, send access code if required.
3. Send phone number in one of the following ways:
• Press and release PTT to send last dialed number.
—
or
—
• when using enhanced keypad microphone only, press preprogrammed
Speed Dial button, followed by a keypad key (1–8), to access first nine
numbers in your phone list. (Press PTT if buffered dial.)
—
or
—
• when using enhanced keypad microphone only, enter phone number using
the keypad. (Press PTT if buffered dial.)
4. Press PTT, hold the microphone 1 to 2 inches (2.5 to 5 cm) from your mouth,
and speak clearly into it.
Ending a Phone Call
1. Send deaccess code if required.
2. Press preprogrammed Phone button.
PRO3100
™
Quick Reference Card
Record the functions for your radio’s programmable buttons in the table
provided below. For further information, see page 4 of this User Guide.
(Interchangeable)
Programmable
Button 2 (P2)
Red/Yellow/Green
LED Indicators
(Interchangeable)
Programmable
Button 1 (P1)
Microphone
Jack
Knob
On/Off/Volume
Channel Selector
Buttons (1, 2, 3 & 4)
Channel Indicators (4)
Button Function Short Press Long Press Hold Down Page
English.book Page 25 Friday, July 23, 1999 1:58 PM
To Next Page
Loading...
