Transceiver Performance Testing Test Mode 3-7
3.3.4 Photosensor Test Mode
1. Press and hold the P1 button after Display Test Mode. The radio beeps once and displays
“Photosensor Test Mode”.
2. Upon any button/ key press, the radio displays “Step 1”, then “Place Radio in Light”, followed
by “Press OK”.
3. Upon the Menu/OK Button press, the radio takes few seconds to read the photosensor and
to compare it with the predefined value, the result of this test is shown at the end of
photosensor mode. The radio displays “Step 2”, then “Cover Photosensor”, followed by
“Press OK”.
4. By pressing the Menu/OK Button the second time, the radio takes a few seconds to read the
photosensor and compare it with the predefined value, the result will then be shown on
screen. The four possible results are:- Photosensor Test Step 1 Failed, Photosensor Test
Step 2 Failed, Photosensor Test Both Steps Failed, or Photosensor Test Passed.
3.3.5 Accelerometer Test Mode
1. Press and hold the P1 button after Photosensor Mode. The radio beeps once and displays
“Accelerometer Test Mode”.
2. Upon any button/ key press, the radio reads the x, y, z position and compare it with the
predefined values (x, y, z) and displays the result on the screen. A pass result will only occur
when the radio is placed in a horizontal position. The possible results are: Accelerometer Test
Failed, Accelerometer Test Passed.
3.3.6 Vibrator Test Mode
Press and hold the P1 button after the Accelerometer Mode. The radio beeps once and vibrates
twice, first a short vibration and second a longer vibration, and displays “Vibrator Test Mode”.
3.3.7 LED Test Mode
1. Press and hold the P1 button after Vibrator Test Mode. The radio beeps once and displays
“LED Test Mode”.
2. Upon any button/key press, the radio’s red LED lights up and displays “Red LED On”.
3. Upon any button/key press following the above display, the red LED turns off. The green LED
will then light up and displays “Green LED On”.
4. Upon any button/key press following the above display, the green LED turns off. Both the
LEDs will then light up and displays “Both LEDs On”.
3.3.8 Backlight Test Mode
1. Press and hold the P1 button after LED Test Mode. The radio beeps once and displays
“Backlight Test Mode”.
2. The radio turns on both LCD and keypad backlight at the same time.
NOTE
Select “Press OK” by pressing the center button of the navigation keys.
NOTE
As there is only one LED on the radio, the LED color is in orange when both the LED lights
up.
To Next Page
Loading...
