Motorola SL4000 - 5.7.5 Back Housing Reassembly

5-20 Disassembly/Reassembly Procedures: Radio Reassembly – Detailed
5.7.5 Back Housing Reassembly
1. Place the back housing onto the front housing as shown in Figure 5-28.
Figure 5-28. Back housing reassembly
2. Using a torque wrench, screw in the self tapping screws at all four corners from back housing
marked (a, b, c, d) by using the 6IP Torx Plus as shown in Figure 5-29.
3. Using a torque wrench, screw in the two machine screws in the battery compartment of the back
housing marked (e and f) by using the 6IP Torx Plus as shown in Figure 5-29.
Figure 5-29. Self tapping screws and machining screws reassembly
Do not over torque these screws. Please refer to the torque
chart on Table 5-5.
Front housing
Back housing
!
C a u t i o n
c
d
e
f
a
b