Disassembly/Reassembly Procedures: Radio Disassembly – Detailed 5-11
5.6.4 PCB Disassembly
1. Unplug the board flex cable and coax cable connector from the main board. To remove the board
to board flex, unlatch the flex connector tab as shown in Figure 5-10.
Figure 5-10. Board flex and coax cable connector disassembly
2. Remove the interface board from the front housing by sliding it out from the PCB retainer catch as
shown in Figure 5-11.
Figure 5-11. Interface board removal
Coax
cable connector
Flex
connector tab
Board Flex
To Next Page
Loading...
