Quick Reference Guide 3
Introduction
This document provides basic instructions for
setting up, programming, and using the
CS3000 series scanners. The scanner is
available in the following configurations:
• CS3000 - USB (batch), 0.5 GB Flash
• CS3070 - USB (batch) and Bluetooth,
0.5 GB Flash
Each scanner includes a USB host cable. A
charging cradle is also available for mounting,
charging, and host connection.
Charging
To charge the CS3000 series scanner, connect
it to a host PC via the USB host cable or
charging cradle. No power supply is
necessary. Charge time is approximately three
hours for a fully discharged battery.
Charging via USB Host Cable
1. Remove the protective cover from the
scanner.
2. Insert the mini-USB connector on the host
cable in the interface port on the scanner.
To Next Page
Loading...
