Why does Motorola Barcode Reader emit a short low/high/low/high beep sequence during programming?
If the Motorola Barcode Reader emits a short low/high/low/high beep sequence while it is being programmed, erase all rules and re-program with shorter rules, as it is out of ADF parameter storage space.
How to troubleshoot Motorola Barcode Reader when nothing happens after pulling the scan button?
If nothing happens when you pull the scan button on your Motorola Barcode Reader, there are a couple of potential causes. First, there may be no power going to the scanner; check the system power and ensure the power supply is properly connected. Second, the interface or power cables might be loose; make sure all cable connections are secure.
What to do if the Motorola Symbol LS1203 Barcode Reader emits laser but doesn't decode?
If the Motorola Barcode Reader emits the laser but does not decode the bar code, the scanner may not be programmed for the correct bar code type. Program the scanner to read the correct bar code type. The bar code symbol may be unreadable, so scan test symbols of the same bar code type to determine if the bar code is defaced. The distance between the scanner and bar code may be incorrect, so move the scanner closer to or further from the bar code. The scan line may not be crossing every bar and space of the symbol, so move the symbol until the scan line is within the acceptable aiming pattern.
Why does the Motorola Symbol LS1203 Barcode Reader display scanned data incorrectly on the host?
If the host displays scanned data incorrectly when using the Motorola Barcode Reader, ensure the proper host is selected by scanning the appropriate host type programming bar code. For RS-232, set the scanner's communication parameters to match the host's settings. For a USB HID keyboard or Keyboard Wedge configuration, program the system for the correct keyboard type and language, and turn off the CAPS LOCK key. Program the proper editing options (e.g., ADF, UPC-E to UPC-A Conversion). Check the scanner’s host type parameters or editing options.
What to do if nothing happens when pressing the trigger button on Motorola Barcode Reader?
If nothing happens when the trigger button is pressed on the Motorola Barcode Reader, check the system power and re-connect the power supply if the configuration requires it. Also, check for loose cable connections and re-connect cables. Verify that the correct host interface cable is used, and if not, connect the correct host interface cable.
Why Motorola Symbol LS1203 decodes but doesn't transmit data?
If the Motorola Barcode Reader decodes the bar code but does not transmit the data to the host, scan the appropriate host type programming bar code. Check for loose cable connection and re-connect cable.
Why does my Motorola Barcode Reader beep frequently?
If the Motorola Barcode Reader emits frequent beeps (USB host interface only), this is normal and usually happens when the host cold boots.
What does it mean when my Motorola Symbol LS1203 emits five long low beeps?
If the Motorola Barcode Reader emits five long low beeps after a bar code is decoded, ensure the scanner’s conversion parameters are properly configured. Change the ADF rule, or change to a host that can support the ADF rule. Change the bar code, or change to a host that can support the bar code.
What to do if Motorola Symbol LS1203 emits four short high beeps?
If the Motorola Barcode Reader emits four short high beeps (USB only), wait several seconds and scan again, as the scanner has not completed initialization.
What does it mean when Motorola Symbol LS1203 Barcode Reader emits four long low beeps?
If the Motorola Barcode Reader emits four long low beeps, check the option setting, as a transmission error was detected in a scanned symbol, and the data is ignored. This occurs if a unit is not properly configured.
General| Brand | Motorola |
|---|---|
| Model | Symbol LS1203 |
| Category | Barcode Reader |
| Language | English |
To Next Page
