Test Procedures
Motorola Confidential Proprietary
50
CDMA T720
TX SAT Deviation Test
Communications Analyzer
Setup
:
• Select TXbutton from the Analog
Screen Control panel
• PWR ismeasured indBm
• Set Frequency Measurement to
auto or manual (display will show
TX Freq. Error)
• SetTXfrequencyto 835.05 MHz
• SetIF filter to 230 kHz
• SetAF Filter1 to 50 Hz
• SetAF Filter 2 to 15 kHz
• SetAF gen1 for 1 kHz frequency
at6V level (output will go to the au-
dio port)
Test Mode Commands:
View FM Deviation for the reading.
The transponded peak SAT FM deviation
should be 2 kHz ±200 Hz.
The demodulated signal on the communi-
cations analyzer should have an audio fre-
quency of 6000 Hz.
TX TEST
Tune Mode
Input Port
RF in/Ant
AFGen1 Freq
1.890
1.0000
KHz
AF Freq
TX Frequency
Auto/Manual
AF Anl In
FM Demod
Detector
Pk+ - Max
AFGen1 Lvl
6.00
V
TX Power
KHz
KHzFM Deviation
MHz
dB
Tune Freq IF Filter
230 kHz
Ext TX Key
On/Off
750 .s /Off
De-Emphasis
15kHz LP F
Filter 2
50 Hz HP F
Filter 1
TX Pwr Zero
Zero
834.990000
6.00000
834.9900
27.60
To Screen
CDMA
CALL CNTL
SMS
AUTHEN
Analog
RX TEST
Config
TESTS
- Suspend Radio
- Load synthesizer to channel 350
- Set power level to power step 2,
- Turn on Carrier
- Enable 6000 Hz SAT tone
Using RadioComm software
To Next Page
Loading...
