Test Procedures
MotorolaConfidential Proprietary
51
TX ST Deviation Test
Communications Analyzer
Setup
:
• SelectTX button from theAnalog
Screen Control panel
• PWR ismeasured indBm
• Set Frequency Measurement to
auto or manual (display will show
TX Freq. Error)
• SetTXfrequencyto835.05MHz
• SetIF filter to 230 kHz
• SetAF Filter 1 to 50 Hz
• SetAF Filter 2 to 15 kHz
• SetAF gen1 for 1 kHz frequency
at6V level (output will go to theau-
dio port)
TestModeCommands:
View FM Deviation for reading.
The peak ST deviation measured on the
communications analyzershould be8kHz
±800 Hz deviation.
The demodulated signal on the communi-
cations analyzer should have an audiofre-
quency of 10 kHz.
TX TEST
Tune Mode
Input P ort
RF in/Ant
AFGen1 Freq
7.890
1.0000
KHz
AF Freq
TX Frequency
Auto/Manual
AF Anl In
FM Demod
Detector
Pk+ - Max
AFGen1 Lvl
6.00
V
TX Power
KHz
KHzFM Deviation
MHz
dB
Tune F req IF Filter
230 kHz
Ext TX Key
On/Off
750 .s /Off
De-Emphasis
15kHz LPF
Filter 2
50 Hz HP F
Filter 1
TX Pwr Zero
Zero
834.990000
10.0000
834.9900
27.60
To Screen
CDMA
CALL CNTL
SMS
AUTHEN
Analog
RX TEST
Config
TESTS
- Suspend Radio
- Load synthesizer to channel 350
- Set power level to power step 2,
- Turn on Carrier
- Enable signaling tone
Using RadioComm software
To Next Page
Loading...
