Disassembly V171
19 August 1, 2004
3. Pry the back housing away from the rest of the phone. You must pry apart the two latches
on the inside of the housing to fully disconnect the two halves as shown in Figure 9.
Figure 9. Prying away the back housing
4. To replace, snap the two halves together again.
5. Replace the two T5 screws securing the back housing to the front and then replace the
stickers covering the two T5 screws.
6. Replace the SIM card and battery.
Removing and Replacing the Speaker
1. Remove the back housing as described earlier.
2. Disconnect the wire connecting the speaker to the transceiver board as shown in Figure
10.
Figure 10. Disconnecting the speaker wire
To Next Page
Loading...
