Level 1-2 Service Manual Disassembly
August 1, 2004 20
3. Pop the speaker out of the speaker bay as shown in Figure 11.
Figure 11. Removing the speaker
4. To replace, insert the speaker into the speaker bay.
5. Reconnect the speaker cable to the transceiver board.
6. Replace the back housing and other parts.
Removing and Replacing the Transceiver Board & Keypad
1. Remove the back housing as described earlier.
2. Disconnect the transceiver board FPC from the transceiver as shown in Figure 12.
Figure 12. Disconnecting the transceiver board FPC
To Next Page
Loading...
