Disassembly V171
25 August 1, 2004
Removing and Replacing the Vibrator
1. Remove the flip screen as described earlier.
2. Pop out the vibrator. It rests in the space atop the LCD screen as shown in Figure 21.
Figure 21. Removing the vibrator
3. Detach the vibrator from the second board (SB).
4. To replace it, gently reconnect the vibrator to the second board (SB).
5. Reinsert the vibrator into its slot above the LCD screen, then press it down.
6. Restore the flips screen and other parts.
Removing and Replacing the Receiver
1. Remove the flip screen as described earlier.
2. Pop out the receiver from the front face of the flip screen as shown in Figure 22.
Figure 22. Removing the Receiver
To Next Page
Loading...
