Level 1-2 Service Manual Disassembly
August 1, 2004 26
3. To replace, insert the receiver into the bay on the front face of the flip screen.
4. Restore the flips screen and other parts.
Removing and Replacing the LCD Module
1. Remove the flip screen as described earlier.
2. Disconnect the FPC cable as shown in Figure 23.
Figure 23. Disconnecting the FPC cable
3. Pry off the LCD screen from the second board (SB).
4. Disconnect the LCD cable
5. Pry off the LCD shielding case as shown in Figure 24.
Figure 24. Removing the LCD shielding case
6. To replace, restore the LCD shielding case.
7. Solder the LCD cable back into place.
8. Place the LCD screen back on the second board (SB).
9. Reconnect the FPC cable.
10. Restore the flips screen and other parts.
To Next Page
Loading...
