Level 1-2 Service Manual Disassembly
August 1, 2004 22
Removing and Replacing the Flip Cover
1. Remove the transceiver board as described earlier.
2. Using a hook tool, press the button inside the joint connecting the flip cover to the front
housing as shown in Figure 15.
Figure 15. Removing the Flip cover
3. Gently remove the FPC cable.
4. Disconnect the two halves as shown in Figure 16.
Figure 16. Disconnecting the two halves
5. To replace, reinsert the FPC cable through the gap, then attach the flip cover to the front
housing. It will snap into place.
6. Replace the transceiver board and other parts.
To Next Page
Loading...
