Level 1-2 Service Manual Disassembly
August 1, 2004 24
3. To replace it, gently snap the microphone into place on the transceiver board.
4. Restore the transceiver board and other parts.
Removing and Replacing the Flip Screen
1. Remove the flip cover as described earlier.
2. Remove the two stickers covering the T5 screws, then remove the screws themselves.
Use must use a star-shaped screwdriver as shown in Figure 19.
Figure 19. Removing two T5 screws
3. Pry off the front face. Four latches on the inside secure it in place as shown in Figure 20.
Figure 20. Prying off the front face
4. To replace, snap the front face into place.
5. Secure two T5 screws, the replace their stickers.
6. Restore the flip cover and other parts.
To Next Page
Loading...
