At the fringe areas of reception, both voice and tone quality start to sound "garbled" or "broken". To
correct this problem, position your radio and Bluetooth-enabled accessory closer to each other (within
the 10 m defined range) to re-establish clear audio reception. The Bluetooth function of your radio has
maximum power of 2.5 mW (4 dBm) at the 10 m range.
Your radio can support up to three simultaneous Bluetooth connections with Bluetooth-enabled
accessory of unique types. For example, a headset, a scanner, a sensor device, and a PTT-Only
Device (POD). Multiple connections with Bluetooth-enabled accessory of the same type are not
supported.
Refer to the user manual of your respective Bluetooth-enabled accessories for more details on the full
capabilities of your Bluetooth-enabled accessory.
12.8.1
Turning Bluetooth On or Off
NOTE: Depending on the configuration of your radio, press or press and hold the Menu/
Programmable button to directly access the feature. Else, manually enter the feature with the
following procedure.
Procedure:
1 Press the Menu/Programmable button.
2 Locate the Bluetooth icon.
3 To turn on Bluetooth, press the Volume Up button. To turn off, press the Volume Down button.
If Bluetooth is on, the following occurs:
• Voice Announcement sounds Bluetooth On.
• The display shows a check mark beside the Bluetooth icon.
If Bluetooth is off, the following occurs:
• Voice Announcement sounds Bluetooth Off.
• The display shows an "X" mark beside the Bluetooth icon.
12.8.2
Searching for Bluetooth Devices
Procedure:
To search for other Bluetooth devices, press the Power/Info button until you see the Bluetooth
icon.
The radio displays Bluetooth Searching icon and Voice Announcement sounds Bluetooth
Searching.
12.8.3
Connecting to Bluetooth Devices
Procedure:
1 While searching, the radio search for the last connected Bluetooth accessory.
Once connected, an indication tone sounds from the connected Bluetooth accessory.
MN005173A01-AD
Chapter 12 : Menu
36
To Next Page
Loading...
