Need help?Do you have a question about the motortronics VMX Series and is the answer not in the manual?
General| Brand | motortronics |
|---|---|
| Model | VMX Series |
| Category | Controller |
| Language | English |
Outlines the essential steps for initial setup and operation of the VMX Series starter.
Provides a list of critical checks to ensure the VMX Series starter is ready for operation.
Instructions for inspecting the unit upon delivery for damage and verifying model number and ratings.
Specifies environmental conditions, location requirements, and mounting procedures for optimal performance.
Critical safety notice emphasizing disconnecting power before servicing to prevent electrical shock.
Guidance on connecting power lines, PFC capacitors, and ground to the VMX Series starter.
Details on connecting the required 120VAC or 240VAC control power supply to the starter.
Step-by-step description of the motor startup sequence and expected VMX Series display/LED behavior.
Details the motor stopping sequence, including Pump-Flex Decel enabled or disabled operation.
How the starter enters Fault Mode and the meaning of fault codes displayed.
Step-by-step guide to changing the Motor FLA setting from 48A to 59A.
Explains how the starter enters Fault Mode and displays codes indicating shutdown causes.
Provides a list of common fault codes, their descriptions, and corresponding LED indicators.
Details the I²t Thermal Overload Protection, simulating bi-metallic relays for motor protection.
Explains the starter's thermal memory and how remaining thermal capacity is displayed.
Instructions on setting the motor's Full Load Amps (FLA) using Function F001.
Information and warnings regarding disabling overload protection.
To Next Page
