3.0 07/2009
- The data and information in this manual are subject to change at any time.
3.4 FUNCTION SELECTION
Select the functions by positioning the dip
switches to ON or OFF, using a screw driver
as shown in the picture.
AUTOMATIC CLOSING
1 ON
The gate closes automatically after a set
time interval from the complete opening; to
adjust it, act on the trimmer described on
page 29.
Automatic closing may be interrupted by a
command from a button, by the transmitter
or by the action of the photocells.
This function deactivates anyhow after a
STOP action or when the power is out.
SEQUENTIAL COMMAND
2 ON + 3 OFF
By pressing the button connected on G-Ps
or that on the transmitter, the command se-
quence will be Open-Stop-Close-Stop.
STEP/STEP COMMAND
2 OFF + 3 OFF
By pressing the button connected on G-Ps
or that on the transmitter, the command
sequence will be Open-Close.
OPEN ONLY COMMAND
2 ON/OFF + 3 ON
Independently of the button, the transmitter
only commands the gate opening .
yes
no
yes
no
yes
no
yes
no
To Next Page
Loading...