3.0 07/2009 - The data and information in this manual are subject to change at any time.
The periodic maintenance action which you may carry out, that do not require any particular prescriptions,
are:
- visual inspections of the gate structure, especially of the hinges and opening and closing endstops;
- inspection of the operator’s area of movement, removing any vegetation that may have grown impeding
the photocells to work properly;
- inspection of the functions of all of the connected devices, making sure they respond to the selections
and functioning modes chosen when installed;
- cleaning of the photocells’ front pieces, using a water-moistened rag (do not use solvents or other
chemical agents).
After disconnecting the main power supply (from the general panel or sectional switch, if present ) you may:
- remove the gearmotor cover, visually inspect the integrity of the connections and clean and visible
devices;
Also do the same with the command panel after opening the small inspection door;
- check that all screws are tight in all of the different devices; lubricate any rotating parts and joints as
well as the gate hinges.
6.0 MAINTENANCE
PERIODIC MAINTENANCE
To Next Page
Loading...