P a g e | 8
User Guidelines – Flosense VNC 09-10-2020 Version 001
IMPORTANT!
The Flosense display need to have 12 digits in the IP-address field in order to successfully
register the IP-address. This means that if you wish to use the IP-address 192.168.4.5, you
will need to enter 192.168.004.005 in the Flosense software.
4) Connect the Flosense display to your unit with VNC software
Use the appropriate VNC connection software of your choice to connect the two devices. In
order to connect to the Flosense display, you will need to enter the IP-address of the
Flosense unit, followed by the Port number (in this example ::5901) as seen below.
Make sure that you have connected your manifolds to your Flosense display before
connecting the units with VNC, as the VNC connection is lost if the Flosense display is
turned off or rebooted.
To Next Page
Loading...