MOULDPRO Flosense 4.0 - Page 16

P a g e | 13
User Guidelines – Flosense 4.0 Manifold 16-06-2020 Version 002
3. Tighten the fitting well, to ensure that the
manifold does not leak.
4. Continue mounting fittings for the rest of the
channels
5. It is possible to fit the fittings in any order, but
it is recommended to finish either the top or
bottom row before starting on the other row.
6. Finish mounting all of the fittings. Once that
is done, the manifold is ready to be connected
to your system.