P a g e | 4
User Guidelines – Flosense 4.0 Manifold 16-06-2020 Version 002
2.6. Directions on Special Hazardous Elements
Only use original cables with the prescribed amperage. If disruption / malfunction of the
electrical energy supply occurs, then stop the Flosense system immediately.
Working on electrical systems or equipment must only be performed by an electrician or by
trained personnel and must be done under supervision and in compliance with electrical
regulations.
When performing inspection-, maintenance- and repair work, Flosense parts must be made
electricity free. It should first be checked that these parts are disconnected (electrically), and
then they are grounded and short circuited. Parts which are mounted near parts which still
are electrical connected, must be insulated.
Risk of metallic corrosion
Galvanic corrosion will occur when different metals are used in the same water installation.
This can potentially lower the lifetime of the product.
Be aware that insufficient grounding of machine parts included in the water system can
increase the corrosion of metal parts.
Corrosion will occur very rapidly if the fluid in the system has PH values higher than 8 or
lower than 5. This will potentially lower the lifetime of the product.
To Next Page
Loading...
