MOULDPRO Flosense 4.0 - Brackets

P a g e | 14
User Guidelines – Flosense 4.0 Manifold 16-06-2020 Version 002
3.5.1. Brackets
If you wish to mount the manifold on a surface, or if you wish to replace the old flow regulator,
Flosense comes with brackets. These brackets are dimensioned so the Flosense system
can replace the flow regulators used on most injection moulding machines, and fit in the
same place.
1. The underside of the flosense has screws in place, which can be removed to place the
brackets.
WARNING! The perforations may be sharp, so be careful when mounting brackets.