Mountfield MTF KD59E - Page 158

EN - 158
11
The temperature sensor inside the motor
has an error
Stop, switch off the bike and wait for the engine
to cool down. If the error appears when the
wheel could not be overloaded, contact the
service center.
12
Error with the current sensor in the
controller
Check the cable connectors and make sure they
are connected correctly, if the error persists,
contact the service center.
14
The protection temperature inside the
controller has reached its maximum value
Stop, switch off the bike and wait for the control
unit to cool down. If the error appears when the
wheel could not be overloaded, contact the
service center.
15
Error with the temperature senor inside the
controller
Stop, switch off the bike and wait for the control
unit to cool down. If the error appears when the
wheel could not be overloaded, contact the
service center.
21
Speed sensor error
Restart the system.
Check the position of the magnet relative to the
sensor.
Check the connectors.
If the problem persists, contact the service
center.
26
Speed signal of the torque sensor has an
error
Check the cable connectors and make sure they
are connected properly. If the problem persists,
contact the service center.
30
Communication problem
Check the cable connectors and make sure they
are connected properly. If the problem persists,
contact the service center.
36
Detection circuit on the keyboard has an
error
Restart the system.
If the problem persists, contact the service
center.
37
Controller WDT circuit is faulty
Please contact your service center
42
Total voltage from the battery is too low
Charge the battery. If the problem persists,
contact the service center.
49
Low voltage of one of the battery cells
Charge the battery. If the problem persists,
contact the service center.
4C
Voltage difference between individual
battery cells
Replace the battery
If error codes other than those listed above are displayed, contact the dealer's authorized service.
If an error code is displayed, have the problem corrected. Otherwise you will not be able to ride the e-
bike normally. Always contact an authorized bicycle dealer.
Beware of safe use. Do not attempt to loosen or reconnect the connector while charging the battery or
while the battery power is on.
Avoid the risk of electric shock.
Do not subject the display to shocks.
Do not modify system parameters to avoid parameter mismatch.