1
INSTALLATION
Selection of Installation Location
Put the unit on a flat location where the air outlets are not
covered up, place the unit no less than 20 inch (500 mm)
away from a wall or other obstacle.
Power cord holder installation
Install the supplied power cord holders with the supplied
two self-tapping screws to the unit.
Exhaust Air Duct Mounting Method
Mounting through the window
1) Shrink the exhaust air duct.
2) Insert the duct into the square adapter.
Rotate the duct (2-3 rounds).
3) Insert the other end of the duct into the window exhaust adapter 1.
Rotate the duct (2-3 rounds). Attach the window exhaust adapter 2.
4) Fix the square end of the duct to the exhaust teminal of the unit.
5) Put the other end (discharge) to the nearest window. See page 18 for window
slider kit installation.
Note: The length of the exhaust air duct is between 24 in (600 mm)-72 in (1800 mm).
When installing, minimum length is recommended.
When mounting, keep the duct horizontal. Do not connect other duct to extend. This
can cause malfunction.
Power cord holder
Window
exhaust
adapter1
Window exhaust adapter2
Exhaust air duct
Square end of exhaust air duct
www.sylvane.com 1-800-934-9194
To Next Page
Loading...
