EasyManuals Logo

Moxa Technologies NPort 5150 User Manual

Moxa Technologies NPort 5150
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #98 background imageLoading...
Page #98 background image
NPort 5000 Series User Manual
98
PPPD Mode
PPPD (PPP on demand) is used for dial-in services, since it provides PPP services only when receiving a
request from a remote PC.
Destination IP address: This is the IP address of the remote dial-in/ dial-out server.
Source IP address: The Source IP address is IP address assigned to this serial port.
IP netmask: The IP netmask defines the netmask, also known as the subnet mask, for the PPP connection
TCP/IP compression (default=Disable): The setting of this field depends on whether the remote user’s
application requests compression.
Inactivity time (default=0 ms): This field specifies the idle time setting for auto-disconnection. A setting of
0 ms will cause the port to remain connected even if idle.
Link quality report (default=Disable): Setting this field to Enable allows the NPort 5000 to disconnect a
connection if the link noise exceeds a certain threshold.
Username: This is the dial-out user ID account.
Password: This is the dial-out user password.
Authentication type (default=None): This field allows you to configure the method used, if any, to verify
a user’s ID and authorization.
Option
Description
Local
Verify the ID against the NPort 5000 User Table.
RADIUS
Verify the ID against the external RADIUS server.
RADIUS-Local
Radius authentication is tried first, switching to Local if unsuccessful.
Local-RADIUS
Authentication is performed locally first, switching to Radius if unsuccessful
TACACS+
Verify the ID against the external TACACS+ server.
TACACS+-Local
TACACS+ authentication is tried first, switching to Local if unsuccessful.
Local-TACACS+
Authentication is performed locally first, switching to Radius if unsuccessful
None
Authentication is not required.
Try next type on authentication denied (default=Disable): The field enables or disables the system to
try next type on first authentication denied.
Disconnect by (default=None): If this field is set as DCD-off, the connection will be disconnected when
the DCD signal is off. If this field is set as DSR-off, the connection will be disconnected when the DSR
signal is off.

Table of Contents

Other manuals for Moxa Technologies NPort 5150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Moxa Technologies NPort 5150 and is the answer not in the manual?

Moxa Technologies NPort 5150 Specifications

General IconGeneral
BrandMoxa Technologies
ModelNPort 5150
CategoryServer
LanguageEnglish

Related product manuals