Locate
Use this function to identify the UPort’s location, especially when two or more UPorts are installed in the same
computer. This function will ask the UPort to flash the ready LED and turn on the Buzzer until you stop it.
Fixed-base COM
Moxa’s UPort 1200/1400/1600 Series Utility gives users a convenient tool for configuring and maintaining
products from the UPort series. In this section, we introduce the “Fixed-base COM Mode” function that enables
user to set COM names on the host PC. We use the UPort 1250 as an example.
Enable Fixed-base COM Mode
Moxa’s UPort 1200/1400/1600 series provides a unique fixed-base COM function that allows users to set a
specific initial COM port number. Regardless of which UPort is plugged into the host, the COM port numbers for
the UPort’s serial ports will be numbered sequentially starting with the initial COM port number. The default
setting is disabling Fixed-base COM Mode. To use “Fixed-base COM Mode,” be sure to check the “Enable
Fixed-base COM Mode” check box.
To Next Page
Loading...
Need help?
General
