MP sava3 - Maintenance Procedures; Return Oil Filter Cleaning; General System Checks

MP sava3 Hidraulic Power Unit 1 ¼” 1 ½”
V700 - 11/2017
20/40
MTMECMPsava3_700_EN
5 • MAINTENANCE
5.1. Cleaning of the reutrn oil filter
5.2. General checks
• Once every 5 to 10 years and depending on the lift general conditions, it is recommended to make a general inspection of all the hydraulic components.
Any worn or old component must be replaced.
• We recommend to filter the oil (the filter should be between 30 and 40 μm) .Clean the tank.
• Change the fitting set (seals and rings) of the cylinder.
• Once the inspection operations have been performed, check all the points as if it was a new installation.
Close the shut-off valve so the power unit and the cylinder are isolated.
Remove the four connection screws of the valve body and open it. Take
out the return filter and clean it correctly. It is very important to set properly
this filter in its housing before the cleaning. Repeat these operations once
per year.