MP sava3 Hidraulic Power Unit 1 ¼” 1 ½”
Disposal of the return pipes in the valve block.
- The return pipes are small union joints on the lower side of the valve block (open the tank’s level cap and have a look at the aforementioned side in order to
identify them) where the hydraulic oil flows through during the different operations of this valve block. Transparent heaths will be inserted into these tubes in
order to verify through which of these the oil is flowing at all times Essential help to localize the existing problem in each different situation.
Speed change electrovalve
Hand pump relief pressure valve
Descent electrovalve
Cylinder minimum pressure regulator
Manual descent push button
Speed change electrovalve
Hand pump relief pressure valve
Descent electrovalve
Cylinder minimum pressure regulator
Manual descent push button
MP sava3 – 20014/33/UE European Directive
To Next Page
Loading...
