2
CRB7 - COMBINATION ROUTER
BASE MK3
Thank you for purchasing the MPOWER
Combination Router Base (CRB7), we hope you
enjoy using it.
The CRB7 should give lasting performance if
used in accordance with these instructions.
SAFETY
Please read and understand the safety points at
the end of these instructions as well as the
power tool instructions before use.
Users must be competent in safe routing
practices before using this product.
FEATURES
• Adjustable Dadoing with a Clamp Guide
• Adjustable Mortising for material
2” (50mm) > 5/16” (125mm)
• Adjustable Anti-tilt support
• Adjustable Groove Copier
• Offset Baseplate
• Small Circle Router Compass:
Min. Radius 3/4” (19mm) >8.13/16”(224mm)
• Large Circle Router Compass
Min. Radius 7” (180mm) > 25” (635mm)
Note: All dimensions shown are based on a
medium sized router being used with a 1/4”
(6.3mm) router cutter.
ITEMS REQUIRED
• Router with a suitable rod size and centers.
• Router cutter / Router bit.
• Clamps.
• 2 x 1/2” (13mm) A/F open ended spanner.
• 5/16” (8mm) A/F open ended spanner.
• Hand Tools.
CONTENTS
3. Items Enclosed
4. Setting Up
Fitting the CRB7 to your router
7. The self adhesive rule
The micro adjuster
The lock bars
8. Operation
Adjustable Dadoing with a Clamp Guide
Adjustable Mortising
Anti-tilt Support
10. Adjustable Groove Copier
Offset Baseplate
11. Cutting Small Circles
Pivot Pin Storage
12. Cutting Large Circles
13. CRB7 Accessories
Maintenance
Environmental Protection
Guarantee
14. Safety Points
The following symbols are used throughout
these instructions.
Denotes risk of personal injury, loss
of life or damage to the tool in case
of non-observance of the
instructions.
Refer to the instruction manual
provided with your power tool.
To Next Page
Loading...