MPP Solar PIP-MS 1-5KVA User Manual

24
Operating Mode Description
Operation mode Description LCD display
Standby mode / Power
saving mode
Note:
*Standby mode: The inverter is
not turned on yet but at this
time, the inverter can charge
battery without AC output.
*Power saving mode: If
enabled, the output of inverter
will be off when connected load
is pretty low or not detected.
No output is supplied by the
unit but it still can charge
batteries.
Charging by utility.
Charging by PV energy.
No charging.
Fault mode
Note:
*Fault mode: Errors are caused
by inside circuit error or external
reasons such as over
temperature, output short
circuited and so on.
PV energy and utility can
charge batteries.
Charging by utility. (Only available in 1K/2K/3K
model)
Charging by PV energy.
No charging.
Fault mode
Note:
*Fault mode: Errors are caused
by inside circuit error or external
reasons such as over
temperature, output short
circuited and so on.
Utility can power loads when
the unit starts up without
battery. (Only available in
4K/5K model with single
operation)
Power from utility
Line Mode
The unit will provide output
power from the mains. It will
also charge the battery at
line mode.
Charging by PV energy
Charging by utility.

MPP Solar PIP-MS 1-5KVA Specifications

General

Brand	MPP Solar
Model	PIP-MS 1-5KVA
Category	Inverter
Language	English